of the line angle, and horizontal and vertical correction. (2) Groove angle The grooved plate is used to cut the extruded sheet into notches. The thinnest notch of the extruded sheet is not less than 15. (3) convex line angle should be cut according to the design size, the line angle and the corresponding extrusion board on both sides of a brush interface agent, and then coated with a special adhesive to make it firmly bonded. 8, wipe the bottom polymer mortar: (1) polymer mortar configuration with a dedicated binder. (2) The configured polymer mortar evenly coated on the extruded board, a thickness of 2. 9, pressed into the grid cloth: (1) grid cloth should be cut according to the length and width of the face, and should set aside the overlap width. Mesh cutting should be carried out along the latitude and longitude. (2) In the windows and doors and other openings around the grid cloth, all four corners should be attached to a layer of grid to strengthen the entire grid should be around the hole in the package and additional mesh cloth above. (3) Apply polymer mortar on the front and sides of the extruded board at the opening and the gridding (only expelled the polymer mortar at the end of the extruded board). Will be thrown before the grid cloth flip along the
non rotting exterior panelscheap peice deck price listoutdoor car cement parking tiles
