ultrafine mill in the use of the process there will always be some failure, it is understandable. But in the face of these failures, are you at your fingertips? Well, let give you a summary of it.
The so-called What kind of disease to eat medicine, for the same
ultrafine mill, different troubleshooting methods are not the same. The following has been classified as a problem, please read carefully one by one.
Question 1: ultrafine mill Drives and Analyzers Fuel Tanks Heat
Produced because: (1) large oil viscosity oil thick, threaded pump oil can not hit the upper bearing short of oil.
Remedy: (1) Check the oil grade and viscosity is consistent with the requirements. (2) Check the operating direction of the analyzer.
Question 2: mill roller device into the powder bearing cup loss
Causes: (1) off the oil, or seal damage. (2) The long-term lack of maintenance and cleaning.
Remedy: (1) according to the provisions of time fuel. (2) Regular cleaning, oil seal replacement.
These three major types of problems are common failures of ultrafine mill. So, when in production, when encountering the above problems, do not be too nervous, one by one investigation can be.
