The Kaolin Milling Equipment Tank Failure

The kaolin milling equipment tank failure is mainly due to air leakage, which generally occurs in the equipment installation stage. Different degrees of water seepage and leakage may occur at the anchor position, and some may appear at the individual welds of the channel bottom channel.

Water seepage and leakage have no effect on the use of the equipment, but have a greater impact on the environment. Troubleshooting and troubleshooting: The surface connection of the tank body must ensure that the rubber is complete and free of deformation.

Fill the flange surface with sealant to seal, strengthen the seal, and pre-tighten the bolts after the joint surface is well connected. If it is found that the gap of the connected tank body leaks, first check whether the bolts are loose and whether the rubber is damaged. Try loosening the preload bolts, refill the sealant if the bolts and rubber or maintenance interval, and then preload the bolts.